Installation Guide

Chapter 3: Operation System information
Page
3-38
Viewing the Network Interface
In any module, the LAN1 Network Interface section of this tab displays the defined Internet Protocol
scheme for the Ethernet interface to the module. In SM/BHS devices, this page also provides an RF
Public Network Interface section, which displays the Internet Protocol scheme defined for network
access through the master device (AP/BHM).
Figure 85 Network Interface tab of the AP
Figure 86 Network Interface tab of the SM
Viewing the Layer 2 Neighbors
In the Layer 2 Neighbors tab, a module reports any device from which it has received a message in Link
Layer Discovery Protocol within the previous two minutes. Given the frequency of LLDP messaging, this
means that the connected device will appear in this tab 30 seconds after it is booted and remain until
two minutes after its shutdown.
Figure 87 Layer 2 Neighbors page