User's Manual

Chapter 9: Operation
Radio Recovery
Page 9-75
Procedure 34 Radio Recovery Console
1
Apply power to PSU for at least 10 seconds.
2
Remove power from the PSU, and then re-apply it as soon as the power indicator light
goes out (about 1 - 2 seconds).
3
When the unit is in recovery mode, access the web interface by entering the default IP
address 169.254.1.1. The Recovery Image Warning page is displayed.
4
Review the Boot Selection (Table 228).
5
Select a recovery option
Figure 186 Recovery Options page
Table 228 Recovery Options attributes
Attribute
Meaning
Boot Selection
Boot – Default Mode: Use this option to temporarily set the IP and
Ethernet attributes to factory defaults until the next reboot.
Boot – Normal: Use this option to reboot the unit.
IP address, Netmask,
Gateway
These fields display IP address, Netmask and Gateway of the radio while
it is in recovery or default mode.