User's Guide Part 1

PTP 25600 reference information Chapter 4 Reference information
phn-0896_009v003
4-18
UNDER DEVELOPMENT
Feb 2010
PTP 25600 regulatory compliance
The PTP 25600 complies with the regulations that are in force in the USA. The
relevant notifications are specified in this section.
U.S. Federal Communication Commission (FCC) notification
This device complies with Part 27 of the US FCC Rules and Regulations. Use of this
product is limited to operators holding Licenses for the specific operating channels.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15E of the US FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio-frequency energy and, if not
installed and used in accordance with these instructions, may cause harmful
interference to radio communications. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to correct the interference by one or
more of the following measures:
• Increase the separation between the affected equipment and the unit;
• Connect the affected equipment to a power outlet on a different circuit from that
which the receiver is connected to;
• Consult the dealer and/or experienced radio/TV technician for help.
• FCC IDs Certification Numbers are listed below:
Where necessary, the end user is responsible for obtaining any National licenses
required to operate this product and these must be obtained before using the product
in any particular country. Contact the appropriate national administrations for details
on the conditions of use for the bands in question and any exceptions that might apply.