User's Guide Part 2

Web-based management Chapter 6 Operation
phn-0896_009v003
6-8
UNDER DEVELOPMENT
Feb 2010
Incompatible Master and Slave
A non-zero value indicates that the master and slave ends of the wireless link are
different hardware products, or have different software versions. Note that it is very
unusual to detect this because incompatible units will normally fail to establish a
wireless link. However, some combinations may establish a partial wireless link and
detect this situation. Note that a non-zero value may generate an SNMP trap and/or
SMTP email alert.
Ethernet Configuration Mismatch
The detection of Ethernet fragments (runt packets) when the link is in full duplex is an
indication of an auto-negotiation or forced configuration mismatch. Note that a change
of state may generate an SNMP trap and/or SMTP email alert.
No Wireless Channel Available
Spectrum Management was unable to locate a suitable wireless channel to operate on.
Note that a change of state may generate an SNMP trap and/or SMTP email alert.
SNTP Synchronization failed
This warning indicates that SNTP has been enabled but that the unit is unable to
synchronize with the specified SNTP server. Section SNTP (Simple Network Time
Prot
ocol) on page 6-117 expl
ains how to configure SNTP. Note that a change of state
may generate an SNMP trap and/or SMTP email alert.
Wireless Link Disabled Warning
This warning is displayed if the Wireless link has been administratively disabled via
the SNMP Interface (see Managing faults on p
age 6-112). The Wireless Interface MIB-
II ifAdminStatus attribute has been set to DOWN. To enable the Ethernet interface, set
the ifAdminStatus attribute to UP. Note that a change of state may generate an SNMP
trap and/or SMTP email alert.
Ethernet Link Disabled Warning
This warning is displayed if the Ethernet link has been administratively disabled via
the SNMP Interface (see Managing faults on p
age 6-112). The Ethernet Interface MIB-
II ifAdminStatus attribute has been set to DOWN. To enable the Ethernet interface, set
the ifAdminStatus attribute to UP. Note that a change of state may generate an SNMP
trap and/or SMTP email alert.
Ethernet Link Status
Current status of the Ethernet link. If there are any problems with the Ethernet
interface, this alarm will be asserted. This alarm will most likely be seen if the unit has
no Ethernet cable plugged into its Ethernet socket. Note that a change of state may
generate an SNMP trap and/or SMTP email alert.