User's Guide Part 2

Web-based management Chapter 6 Operation
phn-0896_009v003
6-16
UNDER DEVELOPMENT
Feb 2010
Receive Modulation Mode Detail
This supplies the user with information regarding the receive modulation mode in use.
Possible values are:
• “Running at maximum receive mode”
• “Running at user-configured Max Modulation Mode”
• “Restricted due to byte errors on the wireless link or local Ethernet Tx Fifo
Drops”
• “Restricted because a DFS channel change is in progress”
• “Restricted due to telecoms acquisition mode”
• “Restricted due to the low Ethernet link speed”
• “Limited by the wireless conditions”
Range
The range between the PTP 600 Series ODUs. This is displayed in km by default, but
can be changed to miles by updating the ‘Distance Units’ attribute to imperial, as
described in Properties on
page 6-131.
TDD synchronization status
The Status Page displays the TDD Synchronization status for the link.
If TDD Synchronization is not enabled, the Attribute is set to “TDD Synchronization
Inactive” and the Value is set to “Timing System Not Connected”.
If TDD Synchronization is enabled and the installation is rebooted, the Attribute is set
to “TDD Synchronization Status” and the Value is set to one of the following:
• Locked: (Figure 6-5)
• Hold
over:
• Holdover (Not Connected)
• Acquiring Lock
• No Timing Reference
• Timing System Not Connected (Figure 6-6)
• In
itialising