User's Guide Part 2

User Guide: PTP 600 Series Installation pages
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-51
Installation pages
There follows a description of the installation pages along with their use during the
installation configuration process. The actual installation process is described in
Manual configuration on
page 6-52.
NOTE
This section assumes that the integrated PTP 600 is being installed. If the
connectorized variant is being installed, refer to Software and features on
pag
e 8-3 for det
ails of the additional functionality that must be configured.
Factory configuration
All wireless links are shipped as paired units. They are pre-configured at the factory so
that they can be installed without the user supplying any configuration. Each wireless
link is shipped with the
PTP 600 Installation Guide . Attached to this guide is a
summary of the pre-configured configuration data. Table 6-7
shows a sample link
configuration. The values in red type have been committed to the wireless unit’s non-
volatile storage.
Table 6-7 Factory configuration values
Example PTP 600 Series Configuration Data
For your convenience these two units have been pre-configured
as a link
Units:
ODU serial number ODU serial number
016780000FFF 016780000FC7
Ethernet MAC address Ethernet MAC address
00:04:56:80:0F:FF 00:04:56:80:0F:C7
Configured as:
Master Slave
Target MAC address Target MAC address
00:04:56:80:0F:C7 00:04:56:80:0F:FF