User's Guide Part 2

User Guide: PTP 600 Series Managing security
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-93
Creating or updating identity-based users
Perform this task to allow multiple users (from one to ten) to access the ODU with
different levels of access. There are three defined levels of access: Security Officer,
System Administrator and Read Only.
NOTE
To ensure that the ODU is compliant with the security requirements of FIPS
140-2, identity-based user accounts must be enabled. For more information,
refer to Configuring FIPS 140-2 mode on
page 6-108.
If identity-based user accounts are already enabled, this task may only be performed
by a user with role set to Security Officer.
To create or update identity-based user accounts, proceed as follows:
Procedure 6-8 Configure user accounts
1
From the left hand menu, select User Accounts. The User Accounts page is
displayed (Figure 6-50).
2
Set the Identity Based User Accounts attribute to “Enabled” (if it is not already set).
3
Create or update up to 10 user accounts (
Table 6-10).
4
If any accounts have been created or updated, select Submit User Account
Updates.