User's Guide Part 2

User Guide: PTP 600 Series Managing security
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-105
Step 6: HTTP and Telnet settings
The PTP 600 can be remotely managed in four ways: HTTPS, HTTP, Telnet or SNMP.
HTTP is the most common and user-friendly. HTTP and Telnet are enabled and
disabled in Step 6 of the Security Wizard. SNMP is configured via the Remote
Management page, and is disabled by default.
To configure HTTP and Telnet via the Security Wizard, proceed as follows:
Procedure 6-16 Configure HTTP and Telnet
1
The Step 6: HTTP and Telnet Settings page is displayed (
Figure 6-60).
2
Review and update the HTTP and Telnet attributes (
Table 6-11).
3
Select Next.
Figure 6-60 Step 6: HTTP and Telnet Settings page