User's Guide Part 2

User Guide: PTP 600 Series Managing faults
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-115
Configuring SNMP notifications
Perform this task to enable the PTP 600 to generate Simple Network Management
Protocol (SNMP) traps.
If SNMP is enabled, then the PTP 600 generates SNMP traps when certain events
occur, and sends the traps to the network SNMP management agent, which notifies
the system administrator.
To configure SNMP notifications, proceed as follows:
Procedure 6-18 Select the SNMP version
1
From the left hand menu, select Remote Management. The Remote Management
page is displayed (
Figure 6-64).
2
Update the SNMP attributes (
Table 6-12).
3
Select Submit Updated Configuration. The Configuration Change Reboot dialog is
displayed.
4
Select Reboot Wireless Unit. The Reboot Confirmation dialog is displayed
5
Select OK. The reboot progress message is displayed. On completion, the unit
restarts.
Table 6-12 SNMP attributes in the Remote Management page
Attribute Meaning
SNMP State ‘Disabled’ means that SNMP traps are not generated.
‘Enabled’ means that SNMP traps will be generated in
response to selected events, and sent to the network
management system.
SNMP Version Select the SNMP protocol version to be used for SNMP traps.
If ‘v1/2c’ is selected, the SNMP Trap Version, Trap IP Address,
Trap Port Number and Community String attributes are
displayed. If ‘v3’ is selected, these attributes are hidden.
SNMP Enabled Traps Select the events that will generate SNMP traps.
SNMP Trap Version Select protocol version v1 or v2c.