User's Guide Part 2

Chapter 7
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
7-1
Chapter 7 Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
This section provides instructions for identifying and correcting faults in a PTP 600
link.
Perform the following procedures either on a newly installed link, or on an operational
link if communication is lost:
Procedure 7-1 Troubleshooting (fault finding)
1
Test the hardware at one end of the link, as described in
Test link end
hardware
on page 7-2.
2
Test the hardware at the other end of the link, as described in
Test link end
hardware
on page 7-2.
3
Test the radio link, as described in
Test radio link on page 7-17.
4
If an installation has been struck by lightning, see
Lightning strike on page
7-19.
5
If an ODU has entered recovery mode, see
Using recovery mode on page 7-
20
.