User's Guide Part 2

User Guide: PTP 600 Series Using recovery mode
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
7-21
Clicking on the warning page image will take the user on to the Recovery Option Page
(Figure 7-7).
Fi
gure 7-7 Recovery Options page
The recovery options available are:
Upgrade Software Image
This allows the user to reload a software image. This may be the original image if
software corruption is suspected or a step back to an old image if an incorrect image
has just been loaded.
Reset IP & Ethernet Configuration back to factory defaults
This allows the user to reset the unit back to the factory defaults:
o IP Address 169.254.1.1 (or 10.10.10.10)
o Netmask 255.255.0.0
o Gateway 169.254.1.0
o Ethernet Interface Auto-negotiate, Auto-MDI/MDIX
Erase Configuration
This allows the user to erase the unit’s entire configuration. Executing this option will
also erase factory settings such as target MAC address, range setting, license key, etc.