User's Guide Part 2

Cable connection procedures Chapter 5 Installation
phn-0896_009v003
5-10
UNDER DEVELOPMENT
Feb 2010
CAUTION
Check that the crimp tool matches the RJ45 connector being used, otherwise
the cable or connector may be damaged.
NOTE
The cable inner sheaf must be located correctly under the connector housing
tang. If this is not done correctly, there is no strain relief on the cable
terminations.
Both ends of the ODU cable are terminated in the same way. The above procedure
should be repeated for the PIDU Plus end of the cable when the cable routing process
is complete. This assumes that the installation uses PTP LPUs. If not, then the PIDU
Plus end of the cable does not require a Gland, but just the RJ45.
NOTE
The PIDU Plus end of the cable does not employ a cable gland.
Figure 5-2 sh
ows a completed ODU to PIDU Plus cable.
Figure 5-2 Completed ODU connector