User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Installing the drop cable and LPU
phn-2182_002v000
May 2011
5-23
3
Fold the ground wire strap around the drop cable screen. Fit cable ties and
tighten with pliers.
4
Cut the surplus from the cable ties. Cut a 38mm (1.5 inches) section of self-
amalgamating tape and fit to the ground cable lug. Wrap the self-
amalgamating tape completely around the lug and cable.
5
Use the remainder of the self-amalgamating tape to wrap the complete
assembly. Press the tape edges together so that there are no gaps.