User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Using the installation wizard
phn-2182_002v000
May 2011
6-15
Step 1: LAN configuration
Step 1 of the Installation wizard is for updating the LAN configuration (Figure 6-15).
The attributes are described in Table 6-1.
Upd
ate IP Address, Subnet Mask and Gateway IP Address to meet network
requirements (as specified by the network administrator). Update the other attributes
as required and select Next.
Figure 6-15 Step 1: LAN Configuration page