User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Using the installation wizard Chapter 6 Configuration and alignment
phn-2182_002v000
6-22
May 2011
Step 4: Email configuration
Step 4 of the Installation wizard is for configuring email notifications (Figure 6-18).
The attributes are described in Table 6-4. Up
date the attributes as required and select
Next.
Figure 6-18 Step 4: Email Configuration page
Table 6-4 Step 4: Email Configuration attributes
Attribute Meaning
Admin Email The email address to which the PTP 250 will send the alert
messages.
Email From The email address used by the PTP 250 to log into the email
server. This must be recognized by the server.
Email Server IP
Address
The IP address of the networked email server.
Email Server Port The port number used by the networked email server. By
convention the default value is 25.