User's Manual Part 1

11
Reset Button
Depression
Action
More than 20 seconds,
whilst the unit is already
powered up.
This resets the configuration to factory defaults.
While connecting power
for more than 40 seconds
after power is applied
This resets to factory defaults and erases any user loaded
software images leaving the factory loaded image intact.
None Power cycle by switching off at the mains. All settings remain
the same.
Table 2 Reset Actions
1.3.3 Mains Power Adaptor
The mains power adaptor is an inline power supply which provides a 48 Volt DC output to
supply power to the IDU / ODU.
Figure 5 OS-Gemini Power Adaptor
Caution Safety may be compromised if a different power supply is used instead of the one
supplied as part of the system.
1.3.4 Cables and Connectors
The cable used to connect the IDU to the ODU can be any standard CAT 5 type provided that it
is suitable for outdoor deployment. Orthogon Systems recommends that cables to the
specification below be used.
NEC/CEC: CMR (ETL) C (ETL) 75C SUN RES OIL RES II