User's Manual Part 1
Table Of Contents
- Getting Started
- Product Architecture
- General Considerations
- Site Planning
- Installation
- Web Page Reference
- Fault Finding
- Specifications
- Lightning Protection
- OS-Gemini C
- FAQs
- Glossary
- Index
21
5 Installation
Orthogon Systems recommends that only qualified personnel undertake the installation of an
OS-Gemini system.
5.1 Preparation
Before proceeding with the installation you should:
• Check the contents of all packages against the parts lists shown in the packing list.
• Ensure that you have the correct tools for the job.
• Ensure that you are qualified to undertake the work.
• Ensure that you have taken the correct safety precautions.
• Have completed the site planning as described in section 4 “Site Planning”.
5.2 Installation Procedure
The OS-Gemini installation procedure consists of the following steps:
• Mounting the ODUs, section 5.6
• Connecting up, section 5.7
• Mounting the IDUs, section 5.7.7
• Powering Up, section 5.7.8
• Aligning the ODUs, section 5.7.9
5.3 Tools Required
The following specific tools are required to install the OS-Gemini in addition to general tools:
• Two 13mm Spanners
• RJ45 Crimp Tool
• IBM Compatible Personal Computer (PC) running Windows 98 or later with 10 or
100baseT Ethernet (Ability to change IP settings easily is recommended)
• Either Internet Explorer version 6 or higher, or Netscape Navigator 7.01 or higher are
recommended.
• 2 x short Ethernet patch cables
• 6mm general purpose crimp tool for the grounding lug (optional for lightning
Protection)