User's Manual

36
6.3.2 Install Pages
These pages are used during system installation. There follows a description of the install pages
along with their use during the installation process. The actual installation process is described in
section 5.5.5 “Aligning the ODUs” above. Step 1 figure 19 will automatically invoke on starting
the installation wizard if there is no valid license key stored. The OS-Gemini operational soft-
ware requires a license key to enable the wireless bridging capability. A license key is supplied
with each unit and can be found in the envelope marked “License Key” pack along with the units
documentation. If subsequently the license key has been mislaid, you can apply for a license
key on line at License Application. Your license key should be entered as shown above and the
“Submit updated values” button pressed.
Figure 19 Licence key entry
Step 2 figure 20 is used to set the IP addresses.
Figure 20 Installation page 1 — Internet Protocol Settings
Step 3 figure 21 is used to set the MAC Address of the peer unit that will be at the other end
of the wireless link. The serial number is the hexadecimal representation of the serial number
written into the last 3 bytes of the units MAC address. At this point it is necessary to decide which
end will be master. The Master unit is the controlling unit with respect to the radio link and its