User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 2: Product Description
16
Hardware overview
Cambium Networks 60 GHz solution consists of Distribution Node which act as Access Point but can connect to other DN. V5000 is
Dual radio Distribution Node. There are two Client node V3000 and V1000 which act as Subscriber Module , they can also be
operated in Point to Point mode.
V1000 – Mid Gain Client node
60 GHz cnWave V1000 is featured with wide-range, 80 degrees beamforming for easy installation. It is powered by 802.3af PoE
and supports up to 2 Gbps with 1 Gbps in the uplink direction and 1 Gbps in the downlink direction.
Figure 3 : V1000 – Mid Gain Client node
Frequency
57 to 66 GHz
Modulation BPSK to 16 QAM (MCS 1 to MCS 12) with ACM
Throughput 1 Gbps Uplink + 1 Gbps Downlink
EIRP 38 dBm
Antenna gain with beam forming
•
+/- 40.0 (Azimuth), +/- 20.0 (Elevation)
•
22.5 dBi (Antenna Gain)
Low latency < 1 ms
Data interface 1 x 1 GE + PoE in (802.3af)
Power consumption 10 W
Physical
•
IP66/67
•
140 x 85 x 40 mm (5.5 x 3.3 x 1.6 Inches), 0.25 kg
(0.55 lbs.)
•
-40 to +60
⁰
C (-40 to +140
⁰
F)