User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 3: System Hardware
23
Radio mounting brackets
V1000 wall and pole mount
The V1000 CN is supplied with a mounting plate and band clamp. The mounting plate can be used for mounting the V1000 on
a wall, or it can be used with the band clamp to mount the V1000 on a pole with diameter in the range 40 mm to 77 mm (1.6 inches
to 3.0 inches).
Figure 4: V1000 mounting plate and band clamp
V1000 adjustable pole mount
The Adjustable Pole Mount is used to provide elevation adjustment when a V1000 CN is mounted on a pole. The Adjustable
Pole Mount works with poles with diameter in the range 40 mm to 77 mm (1.6 inches to 3.0 inches).
Figure 5: V1000 Adjustable Pole Mount
V3000/5000 Tilt Bracket
The Tilt Bracket ("Tilt Bracket Assembly" below) is used to provide elevation adjustment when a V3000 CN or V5000 DN is
mounted on a pole. The Tilt Bracket works with poles with diameter in the range 25 mm to 80 mm (1.0 inches to 3.1 inches).
The Tilt Bracket Assembly may be used with third-party band clamps to mount the ODU on larger pole with diameter in the
range 90 mm to 230 mm (3.6 inches to 9.0 inches).