User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 3: System Hardware
34
V3000, V5000 DC power supply
The V3000 Client Node and V5000 Distribution Node can be powered using DC power at a nominal 54 V, using 14 AWG or 16 AWG
cable, as shown in "DC power supply to V3000 or V5000" below.
Figure 17: DC power supply to V3000 or V5000
The Outdoor PSU can be installed indoors, in an outdoor cabinet, or inside street furniture.
Figure 18: Outdoor AC/DC PSU, 60W, 54VDC
Figure 19: Outdoor AC/DC PSU, 100W, 54VDC