User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 3: System Hardware
41
SFP module kits
SFP module kits allow connection of a V3000 CN or V5000 DN radio to a network over a 10 Gigabit optical Ethernet
interface in one of the following full-duplex modes:
l
10GBASE-SR
l
10GBASE-LR
Order SFP+ module kits from Cambium Networks (" SFP module part numbers" below).
The SFP+ module must be used with the long cable gland.
Table 21: SFP module part numbers
Cambium description Cambium part number
10G SFP+ MMF SR Transceiver, 850nm. -40C to 85C SFP-10G-SR
10G SFP+ SMF LR Transceiver, 1310nm. -40C to 85C SFP-10G-LR
1G SFP MMF SX Transceiver, 850nm. -40C to 85C SFP-1G-SX
1G SFP SMF LX Transceiver, 1310nm. -40C to 85C SFP-1G-LX
10G SFP+ BaseT (RJ45), -40C to 85C
SFP-10G-Cu-EXT
1000Base-T (RJ45) SFP Transceiver. -40C to 85C
SFP-1G-Copper
Cable Gland Long, M25, Qty 5 C000000L124A
Optical cable and connectors
Order an optical cable with LC connectors from a specialist fabricator, quoting the specification shown in " Optical optic cable and
connector specification" below. It must be the correct length to connect the ODU to the other device. LC connectors should be
supplied with dust caps to prevent dust build up.
Figure 25: Optical optic cable and connector specification