User's Guide

Chapter 6: Installation
61
V3000 Tilt bracket assembly
1. Fix the mounting plate of the Tilt Bracket to the back of the radio using four of the short bolts, ensuring that the
arrow in the plate points towards the top of the radio. Tighten the four bolts to a torque setting of 5.0 Nm (3.7 lb ft) using
a 13 mm spanner or socket.
2. Fit the two long bolts through the bracket body so that the bolt heads engage in the slots as shown. Fit two of the
short bolts into the side of the bracket body but do not tighten.
3. Thread two of the nuts to the long bolts and tighten against the bracket body using a 13 mm spanner. Fit the
bracket strap and thread the remaining nuts onto the long bolts.
4. Fix the assembled bracket body to the pole, adjust the azimuth angle, and tighten the nuts to a torque setting of 10.0
Nm (7.4 lb ft) using a 13 mm spanner, ensuring that the arrow in the body is pointing upwards.
5. Fit the mounting plate to the bracket body by positioning the open- ended slots over the short bolts. Insert the
remaining short bolts through the longer curved slots into the threaded holes in the bracket body. Adjust the elevation
angle, and tighten the bolts to a torque setting of 5.0 Nm (3.7 lb ft) using a 13 mm spanner or socket.
V3000 Tilt Bracket assembly with band clamps
1. Follow Step 1 for the Tilt Bracket assembly procedure above.
2. Feed the band clamps through the slots in the bracket body. Secure the bracket body to the pole using band clamps
(not supplied by Cambium), ensuring that the arrow in the body is pointing upwards. Adjust the azimuth angle, and
tighten the band clamps to a torque setting of 6.0 Nm (4.5 lb ft).
3. Fix the mounting plate to the bracket body with four of the short bolts, using a 13 mm spanner or
socket. Adjust the elevation angle, and tighten the bolts to a torque setting of 5.0 Nm (3.7 lb ft).