User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 6: Installation
63
V3000 Precision Bracket
1. Pass two of the long (120 mm) screws through the azimuth arm and the bracket body. The screws locate in the slots in
the azimuth arm.
2. Fit two flanged M8 nuts to the long screws on the back of the bracket. Tighten using a 13 mm spanner.
3. Pass the three medium length (40 mm) M8 screws through the bracket base and the V3000 mount. The screws locate in
the slots in the bracket base.
4. Ensure that the pivot pin in the elevation adjuster is located in the circular hole in the V3000 mount.
5. Fit plain washers and M8 Nyloc nuts to the screws on the back of the bracket base. Tighten using a 13 mm spanner.