User's Guide
Table Of Contents
- Accuracy
- Copyrights
- Restrictions
- License Agreements
- High Risk Materials
- Contents
- Chapter 1: About This User Guide
- Chapter 2: Product Description
- Chapter 3: System Hardware
- Wireless nodes
- V1000 Client Node
- V3000 Client Node
- V5000 Distribution Node
- Radio mounting brackets
- Radio Accessories
- Radio External Interfaces
- Radio specifications
- Power supply units (PSU)
- V1000 power over Ethernet
- V3000, V5000 power over Ethernet
- V3000, V5000 DC power supply
- PSU part numbers
- PSU specifications
- Ethernet and DC cables
- Cable accessories
- SFP module kits
- Chapter 4: System planning
- Chapter 5: Legal and Regulatory information
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Human exposure to radio frequency energy
- Chapter 6: Installation
- Safety
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- AC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- RF exposure near the antenna
- 60 GHz cnWave radios and mounting bracket options
- Installing the cnWave radio nodes
- Mount the radio on the mast
- Install the PSU
Chapter 1: About This User Guide
8
Canada specific information
Renseignements specifiques au Canada
Caution
This device complies with ISEDC ’s license- exempt RSSs. Operation is subject to the following two
conditions:
• undesired
operation of the device.
Attention
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
• brouillage
est susceptible d'en compromettre le fonctionnement.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.