User's Manual

PMP 450 Planning Guide
Access Point (AP)
pmp-0047 (June 2013)
1-7
Table 2 AP interface descriptions and cabling
Interface
Function
Cabling
RF Port – Vertical
Vertical RF connection to AP antenna
50 ohm RF cable, N-type
RF Port – Horizontal
Horizontal RF connection to AP
antenna
50 ohm RF cable, N-type
Sync/Default
GPS synchronization signaling,
provides power to uGPS module.
Default plug port.
RJ11 cable or default plug
Power-over-Ethernet, Ethernet
communications (management
and data)
RJ45 cable
Power-over-Ethernet, Ethernet
communications (management
and data)
RF Port – FSK
For future use
50 ohm RF cable, N-type
Ground Lug (bottom of unit)
For grounding the unit
10 AWG copper wire
AP diagnostic LEDs
The diagnostic LEDs report the following information about the status of the module.
The LED color helps you distinguish position of the LED. The LED color does not indicate any status.
Figure 5 AP diagnostic LEDs, viewed from unit front
PWR
SYN/1
SES/2
GPS/3
ACT/4
LNK/5