User`s manual

8
Connections
Loudspeakers
Check the impedance of your speakers. When using a pair of speakers,
you can use types with an impedance of between 4 and 8 Ohms.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and “phasey”
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8”) or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no
loose ends. Unscrew the speaker terminal, insert the speaker cable,
tighten the terminal and secure the cable.
Record out connection
The diagram below shows how to connect the amplier to a tape recorder
or other component with a record function. Please note that either of the
record outputs can be used (as they are both the same signal in parallel).
Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a CD
player and a pair of loudspeakers.
RightLeftRight Left
BA
RightLeftRightLeft
BA
Rec OutS5S4S3S2S1
Rec OutS5S4S3S2S1
Right
Left
USB Audio In
Right
Left
Loudspeaker Terminals
Power AC
Mains Voltage
Selector Switch:
115V/220-230V
AC~50/60Hz
Right
speaker
Amplier
CD player
Left
speaker
RightLeftRight Left
BA
RightLeftRightLeft
BA
Rec OutS5S4S3S2S1
Rec OutS5S4S3S2S1
Right
Left
USB Audio In
Right
Left
Loudspeaker Terminals
Power AC
Mains Voltage
Selector Switch:
115V/220-230V
AC~50/60Hz
Right
speaker
Amplier
Tape/MD player
left
speaker
Black
Black Black
BlackRed Red
Red Red