Safety Instructions
CXA61/81
7
Front panel controls
Note: Selected sources and functions are represented by a Blue light.
CXA81 has additional Orange lights for Balanced and USB Audio
inputs. CXA61 has an Orange light for USB Audio and MP3 inputs.
1. STANDBY/ON
Switches the unit between Standby mode (indicated by dim power LED)
and On (indicated by bright power LED). Standby mode is a low power
mode where the power consumption is less than 0.5 Watts. The unit
should be left in Standby mode when not in use.
This product has APD (Auto Power Down) enabled as default. After
inactivity of 20 minutes, the product will automatically switch to Standby.
See the 'Setup menu' section for further details.
2. MP3 INPUT (CXA61 ONLY)
This source input allows you to connect a portable audio device such as an
MP3 player directly into the front of the unit using the 3.5mm stereo-jack.
Notes: Plugging in a device into the front panel automatically selects the
MP3 input, any other input can still be selected once this has been done.
The MP3 input can only be selected when an MP3 jack is inserted.
3. HEADPHONES
Allows for the connection of stereo headphones with a 3.5mm jack
plug. Headphones with an impedance of between 8 and 600 ohms are
recommended.
Note: Plugging in headphones will automatically mute the loudspeaker,
pre-out, and sub outputs.
4. ANALOGUE SOURCE SELECT BUTTONS
Push the appropriate input selection button to select the source that you
wish to listen to.
Notes:
– On the CXA61 with an MP3 jack inserted, pressing the A4 input selection
button will toggle between A4 and MP3.
– On the CXA81, pressing the A1 input selection button will toggle between
balance and unbalanced
5. PROTECTION INDICATOR
See the 'CAP5' section for further details.
6. SPEAKER A/B
Press to scroll through the speaker sets connected to the loudspeaker
terminals on the back panel (speaker sets A, B or A and B). This can be
used for listening to an extra set of loudspeakers in another room. See the
'Connections' section for further details.
7. MUTE INDICATOR
The light will ash to show the outputs are muted.
8. DIGITAL SOURCE SELECT BUTTONS
Push the appropriate input selection button to select the source that you
wish to listen to.
Note: Pressing the Bluetooth/USB button repeatedly will toggle between
the two inputs.
9. VOLUME
Use to increase/decrease the level of the sound from the outputs of the
amplier. This control aects the level of all outputs.
1 2 3 4 5 76 98
8