User Manual

Important safety instructions cont.

Ventilation

IMPORTANT – The unit will become warm when in use. Do not stack multiple

units on top of each other. Do not place in an enclosed area such as a

bookcase or in a cabinet without sufficient ventilation.

Ensure that small objects do not fall through any ventilation grille. If this

happens, switch off immediately, disconnect from the mains supply and

contact your dealer for advice.

Positioning

Choose the installation location carefully. Avoid placing it in direct sunlight or

close to a source of heat. No naked flame sources, such as lighted candles,

should be placed on the unit. Also avoid locations subject to vibration and

excessive dust, cold or moisture. The unit can be used in a moderate climate.

This unit must be installed on a sturdy, level surface. Do not place in a sealed

area such as a bookcase or in a cabinet. Do not place the unit on an unstable

surface or shelf. The unit may fall, causing serious injury to a child or adult

as well as serious damage to the product. Do not place other equipment on

top of the unit.

Due to stray magnetic fields, turntables or CRT TVs should not be located

nearby due to possible interference.

Electronic audio components have a running in period of around a week (if

used several hours per day). This will allow the new components to settle down

and the sonic properties will improve over this time.

Power sources

The unit should be operated only from the type of power source indicated on

the marking label. If you are not sure of the type of power-supply to your home,

consult your product dealer or local power company.

To turn the unit off, switch off at the front panel. If you do not intend to use this

unit for a long period of time, unplug it from the mains socket.

Overloading

Do not overload wall outlets or extension cords as this can result in a risk of fire

or electric shock. Overloaded AC outlets, extension cords, frayed power cords,

damaged or cracked wire insulation and broken plugs are dangerous. They may

result in a shock or fire hazard.

Be sure to insert each power cord securely. To prevent hum and noise, do not

bundle the interconnect leads with the power cord or speaker leads.

Cleaning

To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any

cleaning fluids containing alcohol, ammonia or abrasives. Do not spray an

aerosol at or near the unit.

Servicing

These units are not user serviceable. Never attempt to repair, disassemble or

reconstruct the unit if there seems to be a problem. A serious electric shock

could result if this precautionary measure is ignored. In the event of a problem

or failure, please contact your dealer.