Owner's Manual
Table Of Contents
Some countries and
US
states do not allow the exclusion or limitation of
incidental or consequential damages or implied warranties
so
the above
exclusions may not apply to you. This Warranty gives
you
specific legal rights,
and
you
may have other statutory rights, which vary from state to state or
country to country.
FUSE
BLUE
N
Plug
Fitting
Instructions
(UK
Only)
The
cord supplied with this appliance
is
factory fitted with a
UK
mains plug
fitted with a 5 amp fuse inside. If it
is
necessary to change the fuse, it
is
important
that
a 5 amp one
is
used. If the plug needs to be changed
because it is not suitable for your socket, or becomes damaged, it should
be
cut
off
and
an
appropriate plug fitted following the wiring instructions below.
The
plug must then
be
disposed
of
safely, as insertion into a mains socket
is
likely to cause an electrical hazard. Should it be necessary to
fit
a 3-pin
BS
mains plug to the power cord the wires should
be
fitted as shown
in
this
diagram.
The
colours
of
the wires
in
the
mains lead
of
this appliance may not
correspond with the coloured markings identifying the terminals
in
your plug.
Connect them as follows:
The wire which
is
coloured
BLUE
must
be
connected to the terminal which is marked with
the letter 'N' or coloured
BLACK.
The wire which is coloured
BROWN
must be
connected to the terminal which is marked with
the letter
'Lor
coloured
RED.
Limited warranty
Cambridge Audio warrants this product to
be
free from defects
in
materials
and workmanship (subject to the terms set forth below). Cambridge Audio
will repair or replace (at Cambridge Audio's option) this product or any
defective parts
in
this product. Warranty periods may vary from country to
country. If
in
doubt consult your dealer and ensure
that
you
retain proof
of
purchase.
To
obtain warranty service, please contact the Cambridge Audio authorised
dealer from which
you
purchased this product. If your dealer is not equipped
to perform the repair
of
your Cambridge Audio product, it can
be
returned
by
your dealer to Cambridge Audio or an authorised Cambridge Audio service
agent.
You
will need to ship this product
in
either its original packaging or
packaging affording an equal degree
of
protection.
Proof
of
purchase
in
the form of a bill
of
sale or receipted invoice. which is
evidence
that
this product is within the warranty period, must
be
presented
to obtain warranty service.
This Warranty
is
invalid
if
(a) the factory-applied serial number has been
altered or removed from this product or (b) this product was not purchased
from a Cambridge Audio authorised dealer.
You
may call Cambridge Audio or
your local country Cambridge Audio distributor to confirm that
you
have an
unaltered serial number
and/or
you
purchased from a Cambridge Audio
authorised dealer.
This Warranty does not cover cosmetic damage or damage due to acts
of
God, accident, misuse. abuse, negligence, commercial use, or modification
of, or to any part of, the product. This Warranty does not cover damage due
to improper operation, maintenance or installation, or attempted repair
by
anyone other than Cambridge Audio or a Cambridge Audio dealer, or
authorised service agent which is authorised to do Cambridge Audio
warranty work.
Any
unauthorised repairs will void this Warranty. This
Warranty does not cover products sold
AS
IS
or
WITH
ALL
FAULTS.
REPAIRS
OR
REPLACEMENTS
AS
PROVIDED
UNDER
THIS
WARRANTY
ARE
THE
EXCLUSIVE
REMEDY
OF
THE
CONSUMER.
CAMBRIDGE
AUDIO
SHALL
NOT
BE
LIABLE
FOR
ANY
INCIDENTAL
OR
CONSEQUENTIAL
DAMAGES
FOR
BREACH
OF
ANY
EXPRESS
OR
IMPLIED
WARRANTY
IN
THIS
PRODUCT.
EXCEPT
TO
THE
EXTENT
PROHIBITED
BY
LAW,
THIS
WARRANTY
IS
EXCLUSIVE
AND
IN
LIEU
OF
ALL
OTHER
EXPRESS
AND
IMPLIED
WARRANTIES
WHATSOEVER
INCLUDING,
BUT
NOT
LIMITED
TO,
THE
WARRANTY
OF
MERCHANTABILITY
AND
FITNESS
FOR
A
PRACTICAL
PURPOSE.
The wire which is coloured
GREEN/YELLOW
must be connected to the terminal which is
marked with the letter 'E' or coloured
GREEN.
If a standard
13
amp
(BS
1363)
plug
is
used, a 5 amp fuse must
be
fitted,
or
if
any other type
of
plug
is
used a 5 amp fuse must
be
fitted, either
in
the
plug or adaptor, or on the distribution board.
Loudspeakers
Before making any connections to loudspeakers, make sure all power is
turned
off
and only use suitable interconnects.
Power
sources
The
unit should
be
operated only from the type
of
power source indicated
on
the marking label. If
you
are not sure
of
the type
of
power supply to your
home, consult your product dealer or local power company.
This unit can
be
left
in
Standby mode when not
in
use and will draw
<lW
in
this state.
To
turn the unit off, switch
off
at
the
rear panel. If
you
do not
intend to use this unit for a long period
of
time, unplug it from the mains
socket.
Battery
disposal
Please dispose
of
any discharged batteries according
to
local
environmental/electronic waste disposal guidelines.
Ventilation
IMPORTANT
-
The
unit will become hot when
in
use.
Do
not stack multiple
units
on
top
of
each other.
Do
not place
in
an enclosed area such as a
bookcase or
in
a cabinet without sufficient ventilation. Ensure
that
small
objects do not fall through any ventilation grille. If this happens, switch
off
immediately, disconnect from the mains supply and contact your dealer for
advice.
Positioning
Choose the installation location carefully. Avoid placing it
in
direct sunlight or
close to a source
of
heat. No naked flame sources, such as lighted candles,
should
be
placed
on
the unit. Also avoid locations subject to vibration and
excessive dust, cold or moisture.
The
unit can
be
used
in
a moderate
climate.
This unit must be installed on a sturdy, level surface.
Do
not place
in
a
sealed area such as a bookcase or in a cabinet.
Any
space open
at
the back
(such as a dedicated equipment rack) is fine however.
Do
not place the unit
on
an unstable surface or shelf.
The
unit may fall, causing serious injury to
a child or adult as well as serious damage to the product.
Do
not place other
equipment
on
top
of
the unit.
Due to stray magnetic fields turntables or
CRT
TVs
should not be located
nearby due to possible interference. Electronic audio components have a
running
in
period
of
around a week (if used several hours per day). This will
allow the new components to settle down, the sonic properties will improve
over this time.
Cleaning
To
clean the unit, wipe its case with a dry, lint-free cloth.
Do
not use any
cleaning fluids containing alcohol, ammonia or abrasives.
Do
not spray an
aerosol
at
or near the unit.
Servicing
These units are not user serviceable, never attempt to repair, disassemble
or reconstruct the unit
if
there seems to
be
a problem. A serious electric
shock could result
if
this precautionary measure is ignored.
In
the event of a
problem or failure, please contact your dealer.
Overloading
Do
not overload wall outlets or extension cord as this can result
in
a risk
of
fire or electric shock. Overloaded
AC
outlets, extension cords. frayed power
cords, damaged or cracked wire insulation, and broken plugs are dangerous.
They
may result
in
a shock or fire hazard.
Be
sure to insert each power cord securely.
To
prevent hum and noise, do
not bundle the interconnect leads with the power cord or speaker leads.
3