SR10 Your music + our passion ENGLISH Stereo receiver User’s manual 2
Contents Introduction Introduction .................................................................................................2 Thank you for purchasing this Cambridge Audio Topaz SR10 Stereo Receiver. We are confident that you will enjoy many years of listening pleasure from it. Like all Cambridge Audio products, the SR10 adheres to three core principles – stunning performance, ease of use and incredible value. Important safety instructions ........................................................
SR10 ENGLISH Important safety instructions For your own safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power supply. They will also enable you to get the best performance from and prolong the life of the unit: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.
Limited warranty Ventilation IMPORTANT - The unit will become hot when in use. Do not stack multiple units on top of each other. Do not place in an enclosed area such as a bookcase or in a cabinet without sufficient ventilation. Ensure that small objects do not fall through any ventilation grille. If this happens, switch off immediately, disconnect from the mains supply and contact your dealer for advice. Positioning Choose the installation location carefully.
SR10 ENGLISH Rear panel connections 4 Important AM 300Ω Europe FM: 87.50MHz - 108.00MHz US FM: 87.50MHz - 108.00MHz Europe AM: 522kHz - 1629kHz US AM: 530kHz - 1710kHz Service Port 5 Ground Designed and engineered in London, England Loudspeaker Terminals Rated Power Consumption: 500W Impedance 4–8 ohms www.cambridge-audio.
Front panel controls SR10 Stereo Receiver 7 9 1 2 On / Off Phones 3 FM / AM 4 CD BD / DVD MP3 / Aux Phono Speaker A / B 5 Menu 8 Volume Mode / Store 12 11 6 1/6 2/7 3/8 4/9 5 / 10 MP3 In 10 1 Power On/Off Switches the unit on or off. 2 Headphones socket Allows for the connection of stereo headphones with a ¼ inch jack plug. Headphones with an impedance of between 32 and 600 ohms are recommended. Note: Plugging in headphones will automatically mute the loudspeaker outputs.
SR10 The Topaz SR10 is supplied with a remote control that operates this unit and its built-in tuner. In addition, the buttons with Blue coloured icons can operate a matching Topaz CD5 or CD10 player. ENGLISH Remote control CD5/CD10 Always use Alkaline batteries. CD5/CD10 (Blue coloured icons) To operate the Topaz CD5 or CD10 players only. For more information refer to the Topaz CD5 and CD10 user’s manual. Mute Mutes audio on the unit. Press again to cancel mute.
Connections Loudspeakers Check the impedance of your speakers. When using a pair of speakers, you can use types with an impedance of between 4 and 8 Ohms. When using two pairs of speakers, you must use types with an impedance of 8 Ohms each, see later section. Note: All connections are made using standard loudspeaker cable. The red coloured speaker terminals are positive (+) and the black speaker terminals are negative (-).
Speaker B connections Either A or B, or both A and B may be selected for use. The Speaker B connections on the back of the amplifier allow for a second set of speakers to be used (i.e. speakers located in another room). The Speaker A/B button on the front panel and remote control allows the two sets of speakers to be toggled on and off. Refer to the Front Panel or Remote Control section of this manual for more information on the Speaker A/B operation.
Operating instructions After making any connections to your unit, activate the Topaz SR10 by pressing the On/Off button on the front of the unit. Setting the source Mode / Store Press the Source button on the front of the unit corresponding to your desired source. Alternatively, you may use the appropriate button on the remote control. When Auto mode has been selected, press the button to scroll down through the station frequencies or press the button to scroll up through the station frequencies.
SR10 Tuner settings There is no power It is possible to change the tuner region settings for this unit. This can be necessary if the unit has been moved to a different country. Ensure the AC power cord is connected securely. Two settings are possible which set the correct de-emphasis and tuning steps for either North America or Europe/Rest of the world. Note: Changing the tuner settings will clear all stored presets.
Cambridge Audio is a brand of Audio Partnership Plc Registered Office: Gallery Court, Hankey Place, London, SE1 4BB, United Kingdom Registered in England No. 2953313 © 2009 Cambridge Audio Ltd AP25535/1 www.cambridge-audio.
