Manual

ManualsBrandsCambridge Plumbing ManualsPlumbingCAM342-ORB Clawfoot Tub Wall Mount Supply Lines-Oil Rubbed Bronze

Adjustable Wrench

Plumberʼs Tape

Level

It is always suggested to apply plumberʼs tape

to any threads before installation

2.Once the nipple is tightened down, thread

the straight stop valve onto the nipple. The

handle on the valve should be facing away

from the tub for easy access. On top of the

valve will be a compression nut, friction

washer, and rubber cone washer. Take these

off for the next step.

1.Locate the nipple. Attach the nipple to the

water supply on the floor. Slide the escutcheon

down to cover the connection.

342

Before beginning, read the instructions below and follow all local plumbing and

building codes.

Unpack and inspect your new water lines for any shipping damages and ensure

no pieces are missing.

If any damages are discovered DO NOT INSTALL.

SHUT OFF ALL WATER AT THE TUB W HEN INSTALLING.

Please contact custumer service at 1(866)448-Tubs. You may also call our

cuscustomer service for any other assistance with our products.

TOOLS AND MATERIALS NEEDED :

Because tubs can vary in size, measure your working space thoroughly

before installation. Trim pipes accordingly to ensure a correct fit.

Friction Washer (2)

1/2” Nipple (2)

Escutcheon (2)

Rubber Cone Washer (2)

Straight Stop Valve (2)

Slip Nut (2)

Supply Line (2)

Compression Nut (2)

Friction Washer (2)

4. On the opposite end of the supply line, take a

rubber cone washer and place it on the supply

line with the flat side against the lip in the lines.

Slide the slip nut and friction washer that you

put on the pipe in step 3, up to the top of the

lines. Tighten the nut to the faucet through the

moutning holes of the tub.

3. Take a friction washer and slip nut and

slide them onto a supply line. The slip nut

needs to be upsidedown when placing it on

the supply line for later steps.

Place the compression nut, friction washer,

and rubber cone washer on the end of one of

the supply lines in that order. Next, place the

end of the supply line into the top of the stop

valve and tighten the nut down. The waterline

can still move freely so do not pull up when

adjusting or it will be pulled out.

5. Repeat all the steps for the second

water line and once fully installed, turn

on the water to test for leaks.

Summary of content (1 pages)

PAGE 1
342 Bef or e begi nni ng,r ead t he i nst r uct i onsbel ow and f ol l ow al ll ocalpl umbi ng and bui l di ng codes. Unpackand i nspectyournew wat erl i nesf orany shi ppi ng damagesand ensur e no pi ecesar e mi ssi ng. I fany damagesar e di scover ed DO NOTI NSTALL. I ti sal wayssuggest ed t o appl y pl umberʼ st ape t o any t hr eadsbef or ei nst al l at i on 1. Locat et he ni ppl e.At t ach t he ni ppl et ot he wat ersuppl y on t he f l oor .Sl i de t he escut cheon down t o covert he connect i on.