User Manual Part 1

BlueTest Instruction Manual

bc01-an-047b

This material is subject to CSR’s non-disclosure agreement.

Page 10 of 56

BlueCore

Quantitative Tests

Transmitter Only

Title TXDATA1

Summary

Enables the transmitter, with a designated frequency

(LO Freq) and output Power

(Ext, Int)

Payload is PRBS9 data.

Receiver is not operating.

Packet type and duty cycle can be configured. Refer to Configuration Commands

section.

Related Test

Spec Name

TRM/CA/03/C (power control), TRM/CA/04/C (Tx output spectrum – frequency

range), TRM/CA/05/C (Tx output spectrum – 20dB bandwidth), TRM/CA/06/C

(Adjacent channel power), TRM/CA/08/C (Initial carrier frequency tolerance),

TRC/CA/01/C (Out-of-band spurious emissions).

Test Arguments

LO Freq (Carrier Frequency MHz)= 2402 to 2480

Power (Ext, Int) = gain of external amplifier (if present) and internal amplifier. Ext

value is specific to the design and Int value is 0 to 63 (Default = 50).

Return Data

None

Use an RF Analyser to check carrier output.

Exit Click on Reset Chip or select another TXDATA command.

TXDATA1 Example Display

BlueCore

Quantitative Tests

Transmitter Only

Note: TXDATA and RXDATA require the

same Bluetooth address in each module

for

RXDATA to receive data transmitted

TXDATA. Use CFG_UAP_LAP to set

the address used by the BIST.