User Manual Part 3

BlueTest Instruction Manual
bc01 -an-0 47b
© Copyright CSR 2001
This material is subject to CSR’s non-disclosure agreement.
Page 49 of 56
BlueCore
TM
01
Appendix 1
BIST Parameters
Name Type Min Max Meaning
lo_freq
uint16
2402 2480
Bluetooth channel frequency in MHz
lxlvl
uint16
0 63
Internal amplifier power setting. Use
50 for maximum power
mod_freq
uint16
0 65535
Modulation frequency for modulated
carrier transmit test in units of 1/4096
MHz
highside
bool
0 Non-
zero
Receive IF setting, use false (0)
rx_attn
uint16
0 15
Initial attenuation setting, overwritten
by AGC
country_code
uint16
0 3
Simplified hop sequence code, use
country_code 0 for 79 hops
txrx_freq
uint16
1 65535
Period in microseconds between RX
and TX events; default 12500 (20
slots)
lb_offs
uint16
1 65535
Offset in microseconds between
receive and transmit in loopback
report_freq
uint16
1 65535
Time in seconds between reports to
host, default 1
pkt_type
uint16
0 15
Standard Bluetooth packet type (12-
13 disallowed. 0, 1, 2 not useful)
pkt_size
uint16
0 339
Size of payload for packet type
bits_count
uint32
1 4.2 x
10
9
Target for total bits used in BER
measurement; default 1.6 M bit
Reset
bool
0 1
1 resets total count for BER
measurement
offset_half_mhz
int16
-5 +5
Transmit IF offset; default –2
pcm_mode
uint16
0 2
PCM loopback mode; 0 = 4-wire
slave, 1 = 4-wire master, 2 = 2-wire
slave