User Manual Part 3

BlueTest Instruction Manual
bc01 -an-0 47b
© Copyright CSR 2001
This material is subject to CSR’s non-disclosure agreement.
Page 52 of 56
BlueCore
TM
01
Appendix 3
Combining Tests Using a Second Unit
Several tests require a second BlueCore01 unit to be operating to provide a test signal for
the equipment under test. The following table provides a quick reference guide to tests that
use a second unit.
SECOND UNIT PAUSE RADIO STATUS TXSTART TXDATA1 TXDATA2 TXDATA3 TXDATA4 RXSTART RXSTART2 RXDATA1 RXDATA2 BIT ERR1 BIT ERR2 LOOP BACK RX LOOP BACK BER LOOP BACK DEEP SLEEP PCM LB PCM EXT LB SETTLE IF RESP RF IQ MATCH IF IQ MATCH VCO TRIM BUILD LUT READ LUT SET PIO READ PIO PROVOKE FAULT
READ CHIP VERSION
EQUIPMENT UNDER
TEST
PAUSE
RADIO STATUS
TXSTART
TXDATA1
TXDATA2
TXDATA3
TXDATA4
RXSTART1
X
RXSTART2
X
RXDATA1
X
RXDATA2
X
BIT ERR1
X
BIT ERR2
X
LOOP BACK
RX LOOP BACK
X
BER LOOP BACK
X
DEEP SLEEP
PCM LB
PCM EXT LB
SETTLE
IF RESP
RF IQ MATCH
IF IQ MATCH
VCO TRIM
BUILD LUT
READ LUT
SET PIO
READ PIO
PROVOKE FAULT
READ CHIP VERSION