User's Manual
Table Of Contents
- BlueSlim 2™
- Document History
- Trademarks, Patents and Licenses
- Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 System Requirements
- 3 Install BlueSuite
- 4 Install a USB Driver
- 5 Firmware Overview
- 6 Getting Started
- 7 BlueSuite Programs
- 8 TrueTest Toolkit
- 9 Document References
- A Regulatory Notes and Information
- Terms and Definitions
6 Getting Started
When you have connected your BlueCore device(s) to your computer, you can use BlueSuite tools to communicate
with them.
To test you have connected your BlueCore device(s) succesfully, you can use:
■
The command-line tool btcli (Section 7.5).
■
One of the graphical programs PSTool (See the
PSTool User Guide
) or BlueTest3 (See the
BlueTest User
Guide
).
6.1 Exploring the Bluetooth Stack
Use btcli if you want to explore the Bluetooth stack at all before starting development, as it provides a lower-level
interface than the graphical programs in BlueSuite.
The Bluetooth stack is described in the
Specification of the Bluetooth System
from www.bluetooth.com.
Getting Started
CS-212058-UGP1
© Cambridge Silicon Radio Limited 2011
This material is subject to CSR’s non-disclosure agreement.
Page 13 of 24
_äìÉpäáã=O= User Guide