User's Manual

Appendix A Regulatory Notes and Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the two following conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to the transmitter not expressively approved by CSR could void the authority ability to
operate the equipment.
User Label Warning
The transmitter is in compliance with the Part 15 FCC Rules. A label which demonstrates compliance with the FCC
is located on the bottom of the laptop. The label contains the following information:
■
Contains FCC ID:- PIWBLUESLIM2
Transmitter Warning
Installers of the Bluetooth transmitter should note that the Bluetooth transmitter should not be co-located with any
other transmitter, for example WLAN interfaces in the lap top. The distance between the Bluetooth transmitter and
antennas of other radio equipment must be at least 20cm in distance away from each other. Any closer installations
require additional certification filings to examine co-location issues.
A.1 Industry Canada Statements
Operation is subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication.
This device has been designed to operate with the antennas listed below and having a maximum gain of 3dBi.
Antennas not included in this list or having a gain greater than 3dBi are strictly prohibited for use with this device.
The required antenna impedance is 50Ω.
Module BLUESLIM2 uses a printed dual-meander antenna designed by CSR.
A.2 OEM Responsibilities
The BLUESLIM2 Bluetooth Module has been certified for integration into products only by OEM integrators under
the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is maintained between
the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any other antenna or
transmitter.
As long as the two conditions above are met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required with
this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
Important Note:
In the event that these conditions can not be met (for certain configurations or co-location with another
transmitter), then the FCC and Industry Canada authorizations are no longer considered valid and the FCC ID
and IC Certification Number can not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
and Industry Canada authorization.
Regulatory Notes and Information
CS-212058-UGP1
© Cambridge Silicon Radio Limited 2011
This material is subject to CSR’s non-disclosure agreement.
Page 22 of 24
_äìÉpäáã=O= User Guide