Specifications

− 9−
1. Taping shall be right-sided wound. When the end is pulled out, sprocket hole will be at the
right-hand side.
2. For packaging chips by taping, blank spaces are provided on taping as shown in the figure.
・Leader part 400mm min.
・Leader part (Blank part) 20 pockets min.
・Trailer (Blank part) 40 pockets min.
3. Seal tape of plastic taping shall not be crossed over sprocket holes.
4. Plastic tape shall not be seamed.
5. Tensile strength of tape is 5N (0.51kgf) or over.
 6. Number of chips missed from tape reel shall be 1 piece maximum per reel.
 7. Standard number of chips contained in a reel shall be 2,000 pieces.
 8. Label indicating part No., quantity and control No. shall be attached to the outside of reel.
9. Peeling strength of seal tape (or top tape) shall be 0.1〜0.7N (10.2〜71.4gf) when seal tape (or top tape)
is peeled from carrier tape at an angle of 0° 〜 20° .

Tape Packaging (T)
Trailer
Chip packaging area
Leader part
End
Blank part
No shorter than 40 pockets
Blank part
No shorter than 20 pockets
No shorter than 400mm
Feeding direction
Start
0
〜2
0
°