Operation Manual

3
1
Drill a hole about 2 cm
(1 inch) deep into wall.
2
Tap plastic anchor into hole
until it is flush with wall.
3
Screw a M5 x 25 mm screw
into anchor, leaving about
0.5 cm (¼ inch) protruding.
5
Slip keyhole slot of each
rear Satellite onto protruding
screw.
4
Apply rubber
pads on the
back of each
rear Satellite.
1
Thread Speaker Cable
through hole in Stand.
3
Insert attachment arm into socket
at back of Satellite.
5
Apply Identification Label
to back of Satellite.
4
Apply Identification
label to Speaker
Cable.
2
Push back red tab on Satellite.
Insert bare end of red-banded
cable into hole and release tab to
lock. Repeat for unmarked cable;
insert into black tab.
Attachment arm.
❒ Mount the rear Satellites only on walls that are structurally sound.
❒ Position the Satellites behind you and slightly above ear level.
Jupiter020800.fm Page 3 Thursday, August 3, 2000 8:26 AM