Use and Care Manual

9
8. Place gas tank onto the LP support as shown in Figure 8.
Figure 8
9. Attach the metal ring (as shown in Figure 9) pre-fitted with gas hose which is
connected to the table top, into the hole of the door panel, then use hex bolt driver to
screw 1/4"x5mm nut, the gas tank has fixed as shown in Figure 10. Connect the
regulator as shown in Figure10. Screw the black handle clock-wise to tighten. Turn the
handle counterclockwise to remove. The hose must point down. Check that the valve is
turned all the way clockwise to the "OFF" position.
Figure 10
Figure 9