Use and Care Manual

DISPLAY
654321
OPERATING INSTRUCTIONS
LOCATION
The master power switch is located on the right side of the appliance. The control panel is on the right
corner of the glass.
MASTER SWITCH
The master switch controls the power supply to the appliance. Turn the switch to “I” to connect power
and turn the switch to “O” to cut the power. There will be a chiming sound when turning to “I”.
1.POWER ON/OFF
Touch the button once (flame will light up) to turn power on for all functions ，keep the last flame color
once appliance off. Touch the button once more to turn all functions off and flame off.
4.HEAT SETTINGS
This fireplace consists of a fan forced electric heater with two heat settings: 700W (“LO” shown in
display) and 1300 W (“HI” shown in display). Touch the button once (the icon will light up) to activate
the heater at its low level (700W). Touch the button once more to active the heater at its high level
(1300W). When set in high level, touch the button once again to deactivate the heater.
Note: The fan will continue to run for a short time and turns off automatically after the heater is turned
off.
5.TIMER
Set the timer using the button (1 to 9 hours), press button once for 1 hour increments.
2.FLAME ADJUSTMENT
Touch the button to turn flame on. There are 10 colors in total . Press this button to change color.
The display will show F1(the orange color), F2(the orange and green color), F3(green color), F4 (green
and blue color）F5(blue color), F6(blue and orange color), F7(blue and orange and green color), F8(blue
and red color), F9(red color), F0 (all colors loop) to change the different flame color .
3.CHARCOAL FIRE COLOR
Touch the button to turn charcoal fire on. There are 10 colors in total. Press this button to change color.
The display will show C1, C2......C0 (all colors loop) to change the different charcoal fire to same as flame
color.
11
6. Select the temperature display mode of Celcius (C) or Farenheit (F), simply press and hold
button for 10 seconds to change.