Manual

Before beginning, read the instructions below and follow all local plumbing
and building codes.
For this installation of your new wall mounted faucet it is presumed that the
water supply lines are in the wall where the tub will be placed and
are in direct access for faucet installation.
A rounded hole, 1-1/2” in diameter, will provide access to the water supply
lines when mounting lines when mounting the faucet. The distance between the mounting
location to the water supply lines should be approximately 7”
Unpack and inspect your new faucet for any shipping damages and
ensure no pieces are missing.
If any damages are discovered DO NOT INSTALL.
SHUT OFF ALL WATER SUPPLY LINES AT THE TUB W HEN INSTALLING NEW FAUCET
Please contact customer service at 1(866)448-Tubs. You may also call our
customer service for any other assistance with our products.
Screwdriver Plumberʼs Tape Adjustable wrench
684BTW
Includes Wall Mounting Kit
Threaded nipple (2) Silver Metal Washer (2) Washer Nut (2)
Gold Washer (2) Rubber Cone Washer (2) Nut (2)
1. Assuming your water lines are prepared.
Locate a threaded nipple, one silver metal washer,
and a washer nut from the deck mounting kit. Slide the
metal washer down the nipple and thread the washer
nut onto the straight end of the nipple.
2. Th2. Thread the straight end of the nipple into the
waterlines already prepared at the faucet mounting
location. Taking one of your wall shanks, thread it
onto the opposite end of the nipple and tighten to
secure. On the outside of the tub, tighten the washer
nut to secure the water line and shank to the tub.
REPEAT STEPS 1 - 2 FOR THE REMAINING NIPPLE
AND WALL SHANK
3. Taking only the body of the faucet, attach
the body to both wall shanks. Tighten the wall
shanks and faucet together.
4. Thread the spout onto the top of the faucet
body.
5. Remove the nut behind the spout to show a
cone rubber washer. Thread the stand onto the
faucet body with the rubber cone washer remain-
ing in the faucet.
6. Attach the short end of the hose to the stand with
the black washer that is tied to the hose. Now
attach the opposite end to the shower wand. Attach
the shower head to the wand as well.
7. Take the three handles and locate the shower
handle. Place and screw this handle onto the
venter of the faucet body. The HOT/COLD
handles will go on the ends of the faucet body.
HOT on the LEFT and COLD on the RIGHT.