Installation Guide

L
O
W
HIGH
PILOT
Push
to
turn
OFF
I
G
N
I
T
E
HEATER OPERATION
1. Depress and turn control knob clockwise to OFF
position.
2. Fully open gas valve.
3. Depress control knob and turn knob counter
-clockwise to IGNITE position, then to PILOT position
(you will hear 2 clicks).
4. With the pilot light lit, keep control knob depressed
for 30 seconds.
NOTE: If the pilot light has not ignited, turn heater
control knob to OFF position, fully close gas valve,
wait 5 minutes, then repeat steps 2–4 of the
Lighting Instructions.
NOTE: If the pilot light ignites but does not stay lit, turn
heater control knob to OFF position, fully close propane
gas valve, wait 5 minutes, then repeat steps 2–3. Now,
using a lighter, ignite the pilot light through the ignition
hole on the emitter screen.
Once the pilot light is lit, depress control knob for 30
seconds.
5. After depressing the control knob for 30 seconds,
turn control knob to LOW.
To increase the temperature, turn towards HIGH.
1. Fully close gas valve.
2. Turn control knob clockwise to OFF position.
TO TURN ON THE HEATER:
TO TURN OFF THE HEATER:
Variable control knob
Pointer
L
O
W
HIGH
PILOT
Push
to
turn
OFF
I
G
N
I
T
E