Manual

ManualsBrandsCambridge ManualsBath TubsDE67-398684-PKG-ORB-NH Cast Iron Double Ended Clawfoot Tub 67" X 30" with no Faucet Drillings and Complete Oil Rubbed Bronze Free Standing English Telephone Style Faucet with Hand Held Shower Assembly Plumbing Package

Before begining, read the instructions below and follow all local

plumbing and building codes.

For this installation of your new freestanding faucet it is presumed

that the water supply lines are underneath the floor and are in

direct access for faucet installation.

A A rounded hole, 1-1/2” in diamter, will provide access to the water

supply lines when mounting the faucet. The distance between the

mounting location to the water supply lines should be

approximately 7”.

Unpack and inspect your new faucet for any shipping damages and

ensure no pieces are missing.

If any damages are discovered DO NOT INSTALL.

SHUT OFF ALL SHUT OFF ALL WATER SUPPLY LINES AT THE TUB W HEN

INSTALLING NEW FAUCET.

Please contact customer service at 1(866)448-Tubs. You may also

call our customer service for any other assistance with out products.

TOOLS AND MATERIALS NEEDED :

Screwdriver Plumberʼs Tape Adjustable wrench

684-398

4. Taking only the body of the faucet, attach

the body to both swing arms and center the

body. Tighten the swing arm and faucet

together.

5. Thread the spout onto the top of the faucet

body.

6. Remove the nut behind the spout to show a

cone rubber washer. Thread the stand onto the

faucet body with the rubber cone washer remain-

ing in the faucet.

7. Attach the short end of the hose to the stand with

the black washer that is tied to the hose. Now

attach the opposite end to the shower wand. Attach

the shower head to the wand as well.

8. Take the three handles and locate the shower

handle. Place and screw this handle onto the

venter of the faucet body. The HOT/COLD

handles will go on the ends of the faucet body.

HOT on the LEFT and COLD on the RIGHT.

1. Assuming your free standing water lines are

prepared. Locate two risers and thread them onto the

water lines.

2. Tighten these down and ensure they are both facing

the desired direction for installation.

3.3.Take each of the swing arms provided and thread

them onto the open ends of each water line. Before

fully tightening it is important to note that the swings

arms should be centered between the waterlines

approximately 3 3/8” apart.