User Manual

ManualsBrandsCamdapter ManualsCamera StrapsStandard Adapter with Natural Pro Strap

ProStrap

Installation

Instructions

Ease. Comfort. Convenience.

STEP

3.1

STEP

If you are installing a ProStrap

to either an adapter or directly

onto your camera, proceed to

step 2.

If your ProStrap has come pre-

installed to an adapter, proceed

to step 3.2 for installation and

adjustment instructions.

You will need a drinking straw

(or similar item) and about an

inch of Scotch tape.

If you recently purchased your

Camdapter ProStrap, the straw

will already have been installed

for you. Otherwise, insert

the straw through the hand

strap; be sure to go under the

webbing where the sliplock is

located (see Figure 2-A).

NOTE - It is easier to insert

the straw from the top end of

the hand strap (nearest to the

sliplock). When pushing the

straw, do not pinch it, rather

push it with the tip of your

ﬁnger on the very end.

Figure 1.

Figure 2.

2-A

Lace the webbing through

the strap lug on the bottom of

your camera (see Figure 3.1-A)

(or your Camdapter camera

adapter) and back to the end

of the straw (see Figure 3.1-B)

taking care not to twist the

strap.

Pinch the webbing together and

slip it into the end of the straw.

Now, ﬂatten the end and tape

the webbing to the straw (see

Figure 3.1C)

Lay the webbing ﬂat and gently

pull the straw with the attached

webbing back through the hand

strap until the webbing is all the

way through the strap. Discard

the straw and tape.

Figure 3.1

3.1-B

3.1-A

3.1-C

Page 1

For more information and to see other

Camdapter products, visit our website

@ www.camdapter.com

Summary of content (2 pages)

PAGE 1
For more information and to see other Camdapter products, visit our website @ www.camdapter.com Page 1 STEP 1 If you are installing a ProStrap to either an adapter or directly onto your camera, proceed to step 2. If your ProStrap has come preinstalled to an adapter, proceed to step 3.2 for installation and adjustment instructions. Figure 1. STEP 2 You will need a drinking straw (or similar item) and about an inch of Scotch tape.
PAGE 2
For more information and to see other Camdapter products, visit our website @ www.camdapter.com Page 2 STEP 3.2 If you purchased an adapter and a ProStrap together they will come pre-assembled, otherwise attach your adapter to the camera and refer to step 3.1. camera battery compartment, if not most Camdapter camera adapters are reversible to allow more clearance if needed. 3.2-A Using the supplied allen wrench attach the adapter/ProStrap to your camera in the orientation shown in figure 3.2-A.