Owner manual

The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
14
ENGLISH
#,3%.3
/03%.3


/.
/0%.
/0#,
!&
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
/03%.3


/.
/0%.
/0#,
!&
-.

%
%.#2!$)/
!#4
3,/73%.3
7 Programming the end-stops
Mechancal stop
Slide guide
- Release the automation and position the door in the fully opened position.
IMPORTANT: before performing any programming, read the instructions carefully.
Carry out the following instructions in the proper order otherwise the programming will fail.
Preliminary operations
- When the door is fully opened, fasten the mechanical stop to the traction slide.
- Position dip-switch n°1 to ON (the programming signal led fl ashes).
Push and keep pressed the AP/CH switch until the door closes...
Programming the end-stop in the closing phase
- Manually close the door until the release is locked into place again.