User's Guide

Cautions
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures: reorient or relocate the receiving antenna; increase the separation
between the equipment and receiver; connect the equipment into an outlet on a
circuit different from that to which the receiver is connected; consult the dealer or
an experienced radio/TV technician for help. Any changes or modifications not
expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
WARNING: This product can expose you to chemicals including lead, which is
known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information, go to www.p65warnings.ca.gov.
13
CONFORMS TO UL STD.2743
ENERGY PERFORMANCE VERIFIED
Made in China
FCC ID:2AQNC-SH916WC
IC ID:26337-SH916WC
CAN ICES-3(B)/NMB-3(B)
This device complies with part 15 of the FCC rules and contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device