User's Manual

Log In to the Modem Router
TRENDnet DSLR-2001N 22
4.1 Setup Wizard
After you log in, the Setup Wizard appears on the screen. It is
recommended to follow the wizard if are setting up the network and
configuring the Modem Router for the first time.
1. Select a PVC (Permanent Virtual Circuit), then click Next.
It is recommended to use the default setting, PVC0, when
setting up the Modem Router for the first time.
2. The information required on the page below can be obtained
from your Internet service provider (ISP). Consult your ISP
and do the following:
a. Enter the Virtual Path Identifier (VPI) and Virtual
Channel Identifier (VCI).
b. Set the Encapsulation mode, ATMQoS, and Peak Cell Rate.
c. Enable or disable Default VLAN and PPPoE PassThrough.
d. Click Next to continue.