User's Manual

Setup
TRENDnet DSLR-2001N 41
• EAP: Select to use Extensible Authentication Protocol (EAP).
This should only be used when a Radius server is connected
to your Modem Router.
If you select EAP, enter the following information:
• Radius Server IP: The IP address of the authentication
server.
• Radius Server Port: The port number used to connect to
the authentication server.
• Radius Server Key: Enter the passphrase that matches the
authentication server.
Encryption Type — Displays the encryption type you selected.
Group Rekey Time — Enter the number of seconds to elapse until the
Modem Router requires the wireless devices to re-authenticate.
Click the Apply button to save your changes or click the Cancel
button to discard your changes.
5.3 Local Network
To access the Local Network page, click SETUP > Local Network.
LAN
This section contains the local settings of your network. These
settings are private to your internal network and cannot be seen
on the Internet. It is recommended to keep the default values.
IP Address — The default value is 192.168.10.1.
Subnet Mask — The default value is 255.255.255.0.
Local Domain Name — Enter a name to refer to the group of devices
that will be assigned addresses from this pool.
DNS Relay — Select whether to enable or disable the DNS relay
function. Check this box to request automatic assignment of a DNS,
then enter the Primary DNS Server and the Secondary DNS Server in
the DHCP Setting screen below.