User's Manual

Advanced
TRENDnet DSLR-2001N 60
IP Filter
This page allows you to create filter rules to control outgoing
traffic to the Internet based on a range of IP addresses and their
protocols.
To access the IP Filter page, click ADVANCED > Firewall > IP
Filter or click the IP Filter button.
The table lists the existing filter rules. To edit an entry, click
the corresponding icon. To delete an entry, click the
corresponding button.
To add a filter, click the Add button. The IP Filter Config screen
is displayed.
IP Filter — Check this box to enable IP filtering.
Filter Name — Enter a filter rule name.
Start Source IP Address — Enter the starting point of the source
IP address.
End Source IP Address — Enter the ending point of the source IP
address.
Source Port — Enter the source port number.
Start Destination IP Address — Enter the starting point of the
destination IP address.
End Destination IP Address — Enter the ending point of the
destination IP address.
Destination Port — Enter the destination port number.
Protocol Type — Select the protocol from the drop-down list.